Airpad

no stick

Quick actionsneeds USB

Stick–

–

no data yet

signal

–updates / s

–packets lost

–round trip

–mode

–radio awake

On / offwaiting for the stick

What each switch shows is what the stick itself reports. A part that is off stays off through restarts until it is switched on here.

Vibration pattern

–

0 s

Seconds, on then off, then on again: 3,1,5,1 loops. A 0 ends it instead of looping (1,1,1,0), one number is always on, 0 alone stops. Split a round into phases with |, each seconds: pattern: 75:0 | 15:0.5,0.5 stays quiet for 75 s, then pulses for 15 s and stops. @50% after a phase sets its strength. The stick keeps the time itself, so one Start at the top of a round is all it needs (stick 0.10+).

Tune it

⚙️ Settings

Screen Update rate Dim after (s) Screen off after (s) Deep idle after (min) Hold B to blank (s) Brightness Volume Vibration strength Radio power Swing threshold Mic peak threshold Vibration pad Motor runs when the pad is LOW Mic on (loudness only)

Battery savers (a ticked box switches that part off):

Motion sensor off Speaker off Button B off (A only) CPU at 80 MHz Basic mode: A and vibration only, radio checks in 10 times a second, B taps the screen on and off

Presets:

connect USB to change settings

🎵 Sounds & vibration

Vibration pattern Pulse length (ms)

Sound Tone (Hz)

Sound bank: upload a short clip (mono, up to 1.3 s). The stick forgets it on reboot.

Slot Length (s)

🖥️ Stick screen

Template Layout (one row per line) Values (key=value)

A cell is size:color:text, cells in a row split by |. Sizes s m l xl xxl, bar (0 to 100), icon (bolt dot batt wifi ball play check, or a letter), gap. Add .c or .r to the size to centre or right-align the row. Colours white muted cyan pink lime amber red slot auto. {key} is filled from the values; built in: bat chg chgicon player slot link status. A game sends the layout once, then only the values.

New battery test

Name

Vibration

Vibration pattern, from the top of every round

–

Speaker

click on press, whoosh on release

Play a sound every1 press

Hold A for

Then let go for

Each round lasts

Rest between rounds

One round, then the rest

Smart plug

switches the charger off to start and on when the stick dies

After Start, the stick switches to basic mode with these settings, then waits. Take it off the charger (or let the smart plug do it) and it starts pressing A by itself. The receiver times the run until the stick dies, then times the charge back to full.

Chart

All tests

Test	Ran for	Charge	Sticks / 14 h	Pattern
no tests yet

Sticks / 14 h: with no charging during the day, and in brackets when dead sticks charge and swap back in.

USB event log state packets

Sends one JSON line to the receiver over USB. Commands are in PROTOCOL.md.

Receiver over USB

statusnot connected

Receiver over WiFi

Last message of each kind

nothing yet

Quick actionsneeds USB

Stick–

On / offwaiting for the stick

Vibration pattern

Tune it

Running test

New battery test

Chart

All tests

USB event log state packetsClear

Receiver over USB

Receiver over WiFi

Last message of each kind

USB event log state packets